Variable pressure mattress with compressor: the 130 air bubbles are supplied by two airways. One half of the air bubbles, and after 4 minutes the other half, become hard according to the set pressure. This ensures that some parts of the body are only pressurised for a maximum of 4 minutes, after which the weight is released to improve circulation.
- To treat or prevent first stage bloating
- Can be used for long term and home use.
- The aim is to reduce the pressure on the body surface with a gentle massage, which improves circulation and oxygen transport to the blood.
- The mattress works best with loads of 50-100kg
Technical data:
Compressor:
- Power supply: 230V~ -50Hz
- Pressure range: 40 mmHg ÷ 100 mmHg
- Cycle time: 8 minutes (4 minutes of one airway, then 4 minutes of the other airway)
- Power consumption: 10W
- Noise level at 1 m: 46 db
- Protection: F500 mA fuse
- Size: 265(H)mm x 125 (W)mm x 105(D)mm
- Weight: 1.4kg
Mattress:
- Size: 200cmx88cm
- Mattress thickness when inflated: 7cm
- Material: PVC
- PVC thickness: 30 microns
- Weight: 2,3 kg
- 1.5 mm
- Compressor connection with special pipe
- Load capacity :50kg- 100kg
Cleaning, maintenance:
- To clean the mattress, use a neutral detergent with a damp cloth or ordinary disinfectant. Do not use corrosive detergents which may damage the mattress.
- Use a slightly damp cloth to clean the compressor. Do not use any cleaning agent.
Before use, make sure that the tubes are not broken or twisted. Place the flat surface at either end of the mattress under the bed's own mattress. Connect the two tubes of the mattress to the compressor.
Always use a sheet between the mattress and the patient.
Adjust the pressure regulator to the desired setting according to the patient's weight.
